Our webstore uses cookies to offer a better user experience and we recommend you to accept their use to fully enjoy your navigation.
P2796
New product
This is the Adafruit Feather M0 Adalogger - our take on an 'all-in-one' Cortex M0 datalogger (or data-reader) with built-in USB and battery charging. It's an Adafruit Feather M0 with a microSD holder ready to rock!
See description for more details about the product.
Add to cart now!
0 Item Items
This product is no longer in stock
Warning: Last items in stock!
Availability date:
Feather is the new development board from Adafruit, and like its namesake, it is thin, light, and lets you fly! We designed Feather to be a new standard for portable microcontroller cores.
This is the Adafruit Feather M0 Adalogger - our take on an 'all-in-one' Cortex M0 datalogger (or data-reader) with built-in USB and battery charging. It's an Adafruit Feather M0 with a microSD holder ready to rock!
At the Feather M0's heart is an ATSAMD21G18 ARM Cortex M0 processor, clocked at 48 MHz and at 3.3V logic, the same one used in the new Arduino Zero. This chip has a whopping 256K of FLASH (8x more than the Atmega328 or 32u4) and 32K of RAM (16x as much)! This chip comes with built-in USB so it has USB-to-Serial program & debug capability built-in with no need for an FTDI-like chip.
To make it easy to use for portable projects, we added a connector for any of our 3.7V Lithium polymer batteries and built-in battery charging. You don't need a battery, it will run just fine straight from the micro USB connector. But, if you do have a battery, you can take it on the go, then plug in the USB to recharge. The Feather will automatically switch over to USB power when it is available. We also tied the battery thru a divider to an analog pin, so you can measure and monitor the battery voltage to detect when you need a recharge.
Here are some handy specs! Like all Feather M0's you get:
The Feather M0 Adalogger uses the extra space left over to add MicroSD + a green LED:
Comes fully assembled and tested, with a USB bootloader that lets you quickly use it with the Arduino IDE. We also toss in some header so you can solder it in and plug into a solderless breadboard. Lipoly battery, MicroSD card, and USB cable not included (but we do have lots of options in the shop if you'd like!)
It includes the most common resistor values...
$6.00
80 mm Blue Propeller See description for more...
$0.48
5 V 2000 ma Stabilized Power Supply with 5.5 x...
$5.28
The AMS1117-3.3 V voltage regulator module is...
$0.85
This mini momentary tactile switch can be used...
$0.09
This is a blue drilled plastic panel for your...
$0.71
This battery holder making it convenient for...
$0.48
You just found the perfect I2C sensor, and you...
$12.00
Your wearable can now keep you from getting...
$12.00
These 1 x 40 right angle male pin headers are...
$0.36