FormFutura StoneFil Filament - Granite, 1.75 mm, 500 g

Description

This high "stone filling" has resulted in a 3D printer filament with remarkable aesthetic features and a significant higher material density up to 37% higher than "normal" PLA. StoneFil is an easy-to-print 3D printer filament and printed objects have an extremely matte stone-like finish with unique natural gradient color linings resulting in an exceptional chromatic spectrum per print. Every StoneFil printed object will have its own identity and unique gradient color shading.

Unique features

• Easy to print
• 50% gravimetric powdered stone filling
  • ±37% heavier than “normal” PLA
• Matte and rough stone-like finish
• Unique natural/organic gradient color linings
  • Every print has its unique natural stone gradient color shading

General printing guidelines *

*) Above displayed settings are meant as guidance to find your optimal print settings. These ranges in settings should work for most printers, but please do feel free to experiment outside these ranges if you think it is suitable for your printer. There is a lot of different type of printers, hot-ends, and printer offset that it is extremely difficult to give an overall one-size-fits-all setting.

Abrasiveness

StoneFil has a very high filling with stone powders and therefore the filament can have a slightly more abrasive effect on brass nozzles than unfilled filaments.

Filament length

Nozzle cleaning

When printing with filled/composite filaments it is recommended to clean your nozzle immediately after printing by feeding 15-20cm PLA filament through your nozzle. This will make sure that any potential fillers are flown out of your nozzle. It is even better to use glow in the dark PLA as the extremely hard phosphorous particles are much more likely to scrape out residual waste from your nozzle.

Don't delay, buy today.

Add to cart now!